Titan M-4 Mode D'emploi page 3

HAZARD: General
This product can cause severe injury or property damage.
1. Read all instructions and safety precautions before operating
equipment.
2. Never spray near sources of ignition; e.g. open flames, cigarettes — also
cigars and pipes are sources of ignition —, sparks, hot wires and hot
surfaces, etc.
3. Wear respiratory equipment when spraying. The operator must be
provided with a protective mask.
In order to prevent work related illness, the manufacturer's regulations
for the materials, solvents, and cleaning agents used must be observed
when preparing, working with and cleaning the unit. Protective
clothing, gloves, eyewear, and, in certain cases, protective skin cream
are necessary to protect the skin.
4. Follow the coating material and solvent manufacturer's warnings and
instructions.
5. Extraction equipment should be installed by the user in accordance
with local regulations.
6. The objects being sprayed must be earthed.
7. Before each use, check all hoses for cuts, leaks, abrasion or bulging
of cover. Check for damage or movement of couplings. Immediately
replace the hose if any of these conditions exist. Never repair a paint
hose. Replace it with another grounded high-pressure hose.
8. Pulling the trigger causes a recoil force to the hand that is holding the
spray gun.
The recoil force of the spray gun is particularly powerful when the tip
has been removed and a high pressure has been set on the airless high-
pressure pump. Therefore, when cleaning without tip set the pressure
control valve to the lowest pressure.
9. Use only manufacturer authorized parts. User assumes all risks
and liabilities when using parts that do not meet the minimum
specifications and safety devices of the spray gun manufacturer.
M-4/M-8 GB
3