Peg-Perego PRIMO VIAGGIO 360 Notice D'emploi page 15

• Do not use the car seat without its fabric cover;
this must not be replaced with one not approved
by the manufacturer since it is an integral part of
the car seat and the safety system.
• Do not remove the white polystyrene part under
the cover and in the headrest as it is an integral
part of the safety devices.
• Do not leave the car seat in the vehicle when
exposed to the sun. Some parts might heat up
and be harmful to the delicate skin of the child
-check before placing the child in the seat.
• Do not modify the product.
• Do not remove the adhesive and stitched labels
since this might make the product non compliant
with legal requirements.
• For any repairs, replacement parts and information
about the product, contact the after-sales
assistance service. Contact information is provided
on the last page of this manual.
• Do not use accessories not approved by the
manufacturer or by the competent authorities.
• If using a second-hand product, make sure it is a
recent model, comes with instructions, and is fully
functional in all parts. An obsolete product may
not conform to safety standards, due to natural
ageing of materials and updating of regulations. If
you have any doubts, contact the manufacturer's
customer service centre.
• Make sure there are no items of luggage or other
unsecured items in the vehicle interior. They could
injure the vehicle's occupants in the event of an
accident.
Components of the Product
Inspect the content of the package and contact
Customer Care if any items are missing.
The child car seat includes:
a) Dual Stage Cushion
b) Headrest
c) Harness tension release button
d) Adjustment of belt tightness
e) Knob for adjusting inclination
f ) Full 5-point safety harness with shoulder pads
g) Belt clip
h) Seat rotation handle
i) Headrest height adjustment button
l) Instruction manual compartment.
m) Shock-absorbing expanded polystyrene (EPS)
inserts
n) Kinetic Pods: side protections
o) Release to rotate the seat
p) Isofix connector release levers
The car seat is ready for use: no assembly required.
How to install the car seat
1 Check the location of Isofix connectors and Isofix
or i-Size logos on the seats in your vehicle.
2 Expose the Isofix connectors by pulling
simultaneously the two levers located as shown in
the picture, for ease of attachment.
3 Remove the supporting foot from underneath the
base and turn it outwards (fig_a). Position the base
on the vehicle seat as shown in the figure, aligned
with the Isofix connectors (fig_b).
4 Push the base in the direction of the isofix
connectors on the vehicle seat until it clicks in
place. (check that there are no objects in the
vicinity of the connectors that could cause them
to malfunction).
IMPORTANT: the two indicators on the side of
the base will turn from red to green to show that
the base has been connected correctly.
IMPORTANT: after completing the operation,
try moving the seat to verify that the Isofix fittings
have been connected correctly.
5 Pull the 2 front lateral levers on the base
simultaneously (1) and push the car seat against
the vehicle seat as far as it will go (2).
IMPORTANT: You can tell whether the car seat
is positioned correctly from the indicators near the
levers, which will be green if the position is correct,
or red if the position is incorrect, in which case you
15