Installation And Connection - Bartscher 200269 Mode D'emploi

WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with
that of the device (see type label).
Connect the device only in case of compliance! Take note of the security advice!

5.2 Installation and connection

CAUTION!
Installation and connection of the device should be performed only by a qualified
specialist.
•
Unpack the device and remove all packing material. Remove the protective film from
the device.
•
Put the device in a safe place capable of supporting its weight.
•
Never put the device on a flammable surface (e.g. tablecloth, carpet, etc.).
•
To avoid damage to the compressor, when setting up or transporting the device do
not tilt it to a degree in excess of 45º.
•
Do not place the device near sources of open flame, electric ovens, electric heaters
or other heat sources such as direct sunlight. High temperatures may damage the
device's surface and have a negative impact on cooling efficiency and energy use.
•
Place the unit so that appropriate circulation is ensured. Maintain a minimum
distance of 5 cm at the rear, 10 cm at the sides and 30 cm to the ceiling or cabinet.
•
Never block the unit's ventilation ducts.
•
Do not place the unit in locations with high humidity. Excessive humidity
can damage the unit.
•
The unit functions best in ambient temperatures from 10 ° C to 30 ° C and relative
humidity of 30-55% where it is placed.
•
When moving the unit, ensure its adjustable feet and other accessories are not
damaged. Do not lift the unit by its work surface.
•
Do not drill any openings or install any other objects in or on the unit.
•
To adjust the unit's height, turn the adjustable feet until the unit is straight.
•
Do not place any heavy objects on the unit.
•
If the unit has been transported in a vertical position, wait 2 hours prior to connecting
the unit to a power source.
- 25 -