Connecting The Output And Power Supply Cables; Conductor Cross-Sections - Knick ProLine P52000 VPD Manuel Utilisateur

Commissioning

Connecting the Output and Power Supply Cables

The connectors (A and B) can be screwed off for installation.
Connect the cables according to the overview of terminal assignments and
connection. Solid cables or flexible (stranded) cables with ferrules can be
pushed in directly (push-in terminals). To insert a stranded cable without
ferrule, push down the orange locking tab using a flat-bladed screwdriver.
After having connected the cables, tighten the two screws of the connector.

Conductor Cross-Sections

Conductor Cross-Section Min. Max. Unit
Input
Outputs, power supply
Note:
• The stripping length or length of the cable ferrule (without collar)
should be 10 mm.
• Maximum diameter of the jacket or ferrule collar: 4 mm
• For other diameters: Check if the cables are suitable!
B
A
1.5 16 mm
0.25 2.5 mm
2
Single cables with
M5 ring cable lug
2
Single cables,
stranded or solid,
stranded with ferrule
(with or without collar)
55
Push-in
terminals