Knick ProLine P52000 VPD Manuel Utilisateur page 51

Commissioning
Bottom of voltage presence detector
Use your thumbs to push the DIN rail clip (F) in direction of the arrow until it
snaps in. Place the voltage presence detector on the DIN rail and close the
DIN rail clip again.
For removing the voltage presence detector from the DIN rail, we recom-
mend using a flat-bladed screw driver to open the DIN rail clip (see F in fig.
on page 52).
Mounting example:
Voltage presence detector mounted on
TS 35 DIN rail
– input at top, output at bottom
51
F F F F F F