Commissioning; Configuration - Knick ProLine P52000 VPD Manuel Utilisateur

48
Perform the steps for commissioning the voltage presence detector in the
following order:
Configuration › Installation › Measuring voltage and power supply
application
If you have any questions concerning installation or commissioning, please
contact one of our service engineers
by telephone: +49 30 80191-0
by contact form: www.knick.de > Contact > Email to Knick
or send an email directly to: info@knick.de
WARNING! Dangerous touch voltages:
For applications with high working voltages, take measures to prevent acci-
dental contact and make sure that there is sufficient distance or insulation
between adjacent devices.
DO NOT connect the voltage presence detector to power supply or apply
measuring voltage before it is professionally installed.
Installing the optional shock hazard protection:
Correctly install all insulated wires, cable support sleeves, and protective
covers to provide reliable protection against dangerous voltages.
CAUTION! Installation and adjustment in de-energized state:
DO NOT install or adjust the voltage presence detector while it is connected
to measuring voltage or the power supply.
Electrostatic discharge:
Take measures against electrostatic discharge (ESD) when installing or
adjusting the voltage presence detector.
Installation of cables and lines:
Observe the national codes and regulations during installation and selection
of cables and lines.

Configuration

Select the switching thresholds using rotary switch S1.

Commissioning

Note: Only multi-range
models have a rotary
switch.