What To Do If; Environment Concerns - ZANKER KEV6442FBB Notice D'utilisation

What to do if...

Problem
You cannot activate the appliance
or operate it.
A Sound operates and the appli-
ance deactivates.
A sound operates when the appli-
ance is deactivated.
The appliance deactivates.
The residual heat indicator does not
comes on.
The Automatic Heat Up function
does not operate.
You cannot activate outer ring.
The sensor fields become hot.
comes on
and number comes on.
If you tried the above solutions and cannot repair the
problem, speak to your dealer or the customer service.
Give the data from the rating plate, three digit letter
code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.

Environment concerns

The symbol on the product or on its packaging
indicates that this product may not be treated as
20
Possible cause and remedy
• Activate the appliance again and set the heat setting in 10 seconds.
• You touched 2 or more sensor fields at the same time. Only touch one
sensor field.
• The Child Safety Device or the Lock operates. See the chapter Operat-
ing instructions.
• There is water or fat stains on the control panel. Clean the control pan-
el.
You put something on one or more sensor fields. Remove the object from
the sensor fields.
You put something on the
The cooking zone is not hot because it operated only for a short time. If
the cooking zone should be hot, speak to the service centre.
• There is still residual heat on the cooking zone. Let the cooking zone
become sufficiently cool.
• The highest heat setting is set. The highest heat setting has the same
power as the Automatic Heat Up function.
• You decreased the heat setting from
crease the heat setting.
Activate the inner ring first.
The cookware is too large or you out it too near to the controls. Put large
cookware on the rear cooking zones if it is necessary.
The Automatic Switch Off operates. Deactivate the appliance and activate
it again.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some time. Discon-
nect the fuse from the electrical system of the house. Connect again. If
comes on again, speak to the service centre.
Make sure, you operated the appliance correctly. If not
the servicing by a customer service technician or dealer
will not be free of charge, also during the warranty peri-
od. The instructions about the customer service and
conditions of guarantee are in the guarantee booklet.
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
. Remove object from the sensor field.
. Start from and only in-