Instructions For Use; Overview; Attaching The Extension - EUFAB 11583 Mode D'emploi

5. INSTRUCTIONS FOR USE

5.1 OVERVIEW

1 Wheel rail left
2 Wheel rail right
3 Frame holder
4 Safety strap, long
5 Assembly material
6 Cable ties
7 Tensioning strap, short

5.2 ATTACHING THE EXTENSION

NOTE
Before fitting the extension to your bicycle rack, disconnect the electrical cables from the base frame of the
bicycle rack by cutting through the cable ties with cutting pliers.
Step 1:
Remove the brackets for the lamp holders from the outside
of the base frame (left and right).
Figure 3: Removing the retaining clips
Step 3:
Pull the frame extension with the licence plate holder and
the lamp holders out of the base frame until the second pair
of holes in the extension coincide with the holes in the base
frame.
Figure 5: Pulling out the frame extension
12
6
5
5
4
Step 2:
Remove the retaining screws from the base frame.
(Left and right).
Figure 4: Removing the retaining screws
Step 4:
Replace the retaining screws (left and right).
Figure 6: Inserting the retaining screws
1
2
7
3
Figure 2: Overview