EUFAB 11583 Mode D'emploi page 13

Step 5:
Fasten the brackets for the lamp holders to the outside of the
frame extension using the screws and spacers (mounting
material position 5 in the overview) (left and right).
The rounding of the holder clamp must point downwards.
Figure 7: Mounting the retaining clips
Step 7:
Fasten the wheel rail with the lock bolts, washers and nuts
(installation material position 5 in the overview). After
tightening the nuts, place the protective caps on the nuts (left
and right).
Figure 9: Tightening the wheel rail
Laying electrical cables
Lay the cables along the tube of the base frame. The cables may not be bent, stretched or crushed, e.g. in the vicinity of the
folding mechanism. Secure the cables with the supplied cable ties (Position 6 in the overview). When you are finished, trim
any excess material from the cable ties using cutting pliers.
Mounting the short tensioning strap
Figure 10: 3 x short tensioning strap
Insert the short tensioning strap from the inside to the outside below the bike holder and then from the outside to the
inside through the slots of the bike holder (Figure 11). For the rear wheel of the bicycle, use the centre slot of the wheel
holder, for the front wheel, use the two outer slots (two tensioning straps to prevent the front wheel from turning).
Step 6:
Place the wheel rails with the hinge on the frame
extension. Make sure that the nut with the protective
cap of the hinge points backwards (left and right).
Nut with protective cap to the rear
Nut with protective cap to the rear
Figure 8: Mounting the wheel rail
Figure 11: Mounting the tensioning straps
13