Tunturi CROSS-TRAINER C3 Mode D'emploi page 3

F R O N T F R A ME TU BE
Remove the rubber band from around meter
cable coming from the frame tube and the four
attachment screws with washers. Attach the meter
cable to the connector coming from the front
frame tube. Set the adjustment knob so that
number 8 is shown in the display and attach the
end of the brake wire coming from the front frame
tube to the wire coming from the frame tube.
Push the front frame tube inside the frame tube:
do not damage the meter cable! Attach the front
frame tube tight to the frame with the washers and
attachment screws.
C3_ohje 2-3
O W N E R ' S M A N U A L • C 3
A R MS
Push the metal shaft through the bracket housing
of the left arm. Attach now the left arm to the front
frame tube by pushing the metal shaft through the
opening in the tube. Push the right arm on the
shaft and lock it by tightening a large washer, a
locking sleeve and a screw to the both ends of
the shaft. Tighten the arms using two Allen keys.
Push the left footrest support forward so that you
can push the adjustment tube in the front of the
foot rest support inside the arm tube. Select the
appropriate adjustment (see Adjusting the footrest
supports) and lock the adjustment tube with the
locking screw. Repeat the procedure with the right
footrest support.
22.3.2002, 12:41
G B
3