Harman JBL Club A754 Mode D'emploi page 4

IMPORTANT: Disconnect the vehicle's negative (–) battery
terminal before beginning the installation.
• Always wear protective eyewear when using tools.
• Choose a safe mounting location, away from moisture. Check
clearances on both sides of a planned mounting surface. Be
sure that screws or wires will not puncture brake lines, fuel
lines, or wiring harnesses and that wire routing will not interfere
with the safe vehicle operation. Use caution when drilling or
cutting in the mounting area.
EN
• Choose a location that provides enough air circulation.
• Do not mount the amplifier with the heat sink facing downward,
as this interferes with cooling.
• Mount the amplifier so that it will not be damaged by the feet of
backseat passengers or shifting cargo in the trunk.
WIRING FOR POWER AND GROUND
At amplifier:
+12V
Fuse holder, fuse
18" (46cm)
Battery
(used only with low-level signal inputs)
At ground location:
Factory Bolt Ring Connector
Note: Remove any paint
below ring connector
WIRING FOR INPUT SIGNAL
Club A754 low-level signals
FRONT REAR PRE OUT
L
R
From stereo front
low-level outputs
From stereo rear
low-level outputs
Note: when using low-level signals and remote turn-on lead, set
the " " switch to "
switch to " ".
REM GND
Chassis ground (–)
Remote turn-on to
aftermarket stereo REM out
Ground Wire
Star Washer
To optional
second amplifier
low-level inputs
" and the "
Club A5055 low-level signals
From stereo front
low-level outputs
From stereo rear
low-level outputs
Note: when using low-level signals and remote turn-on lead with
the Club A5055, set the "
SUB " " switch to "
to " ".
Club A754 high-level signals
Loosen
Screws
L
Stereo front
speaker wires
Stereo rear
speaker wires
Note: when using high-level signals, set the "
switch to " " and the "
sound plays, change the "
Club A5055 high-level input signals
Stereo front
speaker wires
"
Note: when using high-level signals with the Club A5055, set the
" " switch to "
" ", and the "
change the "
FRONT REAR SUB
L
R
From stereo subwoofer
low-level outputs
" switch to "
", and the " " switch
Insert Tignten
Wires Screws
FRONT REAR PRE OUT
R
To optional
second amplifier
low-level inputs
" switch to " ". If no
" switch to " ".
FRONT REAR SUB
L
R
Stereo rear
speaker wires
", the SUB " " switch to
" switch to " ". If no sound plays,
" switch to " ".
", the
"