Cleaning The Appliance; Removing And Cleaning The Guide Rails - ETNA OM948RVS Mode D'emploi

CLEANING

Cleaning the appliance

Clean your appliance regularly to prevent a build-up of grease and food particles, especially on
interior and exterior surfaces, the door and door gasket.
• Clean the exterior surfaces with a soft cloth and soapy warm water.
• Wipe afterwards with a clean, damp cloth and dry the surfaces.
• Remove splashes and stains on the interior surfaces with a soapy cloth.
• Wipe afterwards with a clean, damp cloth and dry the surfaces.
Take care that no water enters the vents.
Never use abrasive cleaning agents or chemical solvents.
Ensure that the door gasket is always clean. This will prevent a build-up of dirt so
that the door can close properly.

Removing and cleaning the guide rails

Use conventional cleaning products to clean the guide rails.
• Remove the screws on the top of the guide rails or push down the upper wire of the guide
rail to release it from the screw.
• Remove the guide rails from the holes in the side walls.
EN 14