Alarm Messages - CTC SmartControl Manuel D'installation Et De Maintenance

English
45.3

Alarm messages

Alarm: [E155] SmartControl
Reset alarm
The following SmartControl-related alarm messages may be shown on the
display.
[E155] SmartControl
This alarm message is displayed when a communications error has occurred
between Gateway and the display.
[E156] Sensor rH
This is displayed if Gateway has not registered a reading from a connected
room/humidity sensor's rH element for a period of time (1 hour, hard-coded).
[E157] Sensor CO2
This is displayed if Gateway has not registered a reading from a connected
room/humidity sensor/CO2 sensor's carbon dioxide element for a period of
time (1 hour, hard-coded).
[E074] Room sensor 1
This is displayed if Gateway has not registered a reading from a connected
room sensor in heating system 1 for a period of time (1 hour, hard-coded).
[E075] Room sensor 2
This is displayed if Gateway has not registered a reading from a connected
room sensor in heating system 2 for a period of time (1 hour, hard-coded).
EN
82
CTC SmartControl