Touchscreen; Define System - CTC SmartControl Manuel D'installation Et De Maintenance

45. Touchscreen

From the start menu you can access all submenus for
heating, hot water and ventilation system.
The menus for defi ning the CTC SmartControl
accessories can be accessed via the "Installer" button,
which is located in the top right corner of the start
menu.
For detailed information about all display menus
available on the main product, please see Installation
and Maintenance Manual .
45.1 Defi ne system
Check that the devices to be controlled by the
SmartControl accessories have been defi ned. To defi ne
"Ventilation", EcoVent (20/25) must be selected in
the "Ventilation" menu row in the "Installer / Defi ne /
Ventilation" menu, as shown in the menu image. For the
main product CTC EcoVent i360F, the ventilation unit is
pre-defi ned (factory setting "Ventilation-Yes" in this row).
45.1.1 Defi ne SmartControl
accessories
SmartControl accessories are defi ned/connected to
the system in the menu Advanced/Defi ne system/
SmartControl.
Move down to the line SmartControl and press OK.
Pairing accessories with Gateway
• Select Yes in the line SmartControl to show
the 7 channels (#1 to #7) available for wireless
connection of SmartControl accessories to the
system.
It doesn't matter which accessory is placed on
which channel.
• Choose a line using the cursor and press the
OK button; Pair will appear on this line. Press the
OK button again.
• Press the Learn button on the accessory. See
the chapters for the respective accessories for
information on where the Learn button is located.
To connect a multi-button, choose a channel in
the same way and press the button.
Pairing should be implemented within 30 s (in the
example in the menu fi gure above, 23 s remain for
establishing contact ) .
• Connect other accessories to available channels.
Start menu.
Menu "Installer / Defi ne".
Menu "Installer / Defi ne / Ventilation".
Menu "Installer / Defi ne / SmartControl".
English
EN
79