Room Sensor; General; Installation; First Start - CTC SmartControl Manuel D'installation Et De Maintenance

39. Room sensor

General

39.1
The wireless room sensor is powered by the integrated solar cells, which can
be supplemented by the supplied battery (1/2 AA, 3,6 V) if light levels are
low.
The sensor is connected to the wireless network via the main product
display. This is described in menu chapter Touchscreen .
39.2

Installation

The room sensor should be placed in a suitable location in the home that is
representative of the temperature in the room, not in a draughty location or
near a heat source. If possible, position the sensor where the solar cells can
be charged by natural daylight.
• To remove the base plate, push in the latch at the bottom of the sensor
with a screwdriver.
• Use screws to attach the base plate of the sensor to a flat wall surface.
• Connect the sensor to the system using the software, see chapter First
start below.
• Push the cover onto the base plate.
39.3

First start

Connect/define the room sensor to the wireless system by selecting a
vacant channel position in the Define menu on the display and then pushing
the "learn button" on the sensor. For detailed information, see chapter
Touchscreen/ Define SmartControl accessories .
To connect the sensor to the current heating system, see chapter
Touchscreen/Define SmartControl accessories.
English
"Learn button": to connect
to/pair the sensor with
Gateway
Latch to remove base plate
CTC SmartControl
EN
73