Babyauto Patxu Notice D'instruction page 29

5. Fasten the seat belt into the vehicle´s buckle until
it "clicks", making sure the child seat is properly
installed (3.9).
6. Tighten the lap belt and diagonal shoulder belt, then
place the red safety clip
belt tongue as near to the vehicle anchor point as
possible without touching it! (3.9, 3.10, 3.11 y 3.12).
Make sure the vehicle's safety belt is not twisted,
also check that the seat cover does not impede the
movement of the vehicle's safety belt or prevent
the installation of the seat in any way. To release
your child unbuckle the vehicle safety belt as
described in the instructions.
IMPORTANT
Ensure that the belt has no slack.
4. INSTALLING CHILD SEAT. GROUP 1.
WARNING
Installing the child seat forward facing can only be maid
if the child is more than 9 kg.
1. Take of the 0 basic and change is postion, then press
it inside you will hear a "click" (4.1).
2.Fit this child seat into the vehicle´s seat, making sure
it is firmly pressed against the vehicle seat backrest
(4.2).
3. Pass the lap belt through the
seat backrest and fasten the safety belt to the
vehicle anchor point. You will hear a "click" when
properly fastened (4.3, 4.4, 4.5 y 4.6).
Group 0/1
N on the diagonal shoulder
Only suitable for Group 1, approx.
9 months to 4 years of age (9-18 Kg.)
I and J guides in the
www.babyauto.com
EN
29 29