Disposal And Recycling; Troubleshooting - Scheppach DP50 Traduction Des Instructions D'origine

15. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled.
The equipment and its accessories are made of vari-
ous types of material, such as metal and plastic. De-
fective components must be disposed of as special
waste. Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly
disposing of this product, you are also contributing
to the effective use of natural resources. You can
obtain information on collection points for waste
equipment from your municipal administration, pub-
lic waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.

16. Troubleshooting

Fault Possible cause
Motor, cable or plug defective, building
circuit breaker tripped
Device does not start
On/off switch (10/9) defective
Motor defective
Base plate (1) not fastened in place
Heavy vibrations
Drill bit not clamped centrally
Overloading of the motor, insufficient cool-
Motor overheats easily
ing of the motor
Motor makes exces-
Coils damaged, motor defective
sive noise
26 GB
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
Remedy
Check power outlet, mains connection cable,
mains plug. Have repair carried out by electrical
specialist. Check building circuit breakers.
Repair by customer service department
Repair by customer service department
Secure machine to a work bench or similar
Check drill bit in chuck (14)
Avoid overloading the motor while drilling,
remove dust from the motor in order to ensure
optimal cooling of the motor.
Have checked by customer service department