Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.5 OptiHeat Control (3 step
Residual heat indicator)
WARNING!
burns from residual heat.
The indicator shows the level
of the residual heat.
4. DAILY USE
WARNING!
Refer to Safety chapters.
4.1 Activating and
deactivating
Touch
for 1 second to activate or
deactivate the hob.
4.2 Automatic Switch Off
The function deactivates the hob
automatically if:
• All roasting zones are deactivated.
• You do not set the temperature after
you activate the hob.
• You spill something or put something
on the control panel for more than 10
seconds, (a pan, a cloth, etc.). An
acoustic signal sounds and the hob
deactivates. Remove the object or
clean the control panel.
• You do not deactivate a roasting zone
or change the temperature. After 90
minutes
deactivates. Before next use, set the
roasting zone to
4.3 The heat setting
To set or change the heat setting:
Touch the control bar at the correct heat
setting or move your finger along the
control bar until you reach the correct
heat setting.
The display flashes until the roasting
zone reaches the temperature. Then a
signal sounds and the display shows the
temperature.
/
/
There is a risk of
comes on and the hob
.
The induction cooking zones make the
heat necessary for cooking process
directly in the bottom of the cookware.
The glass ceramic is heated by the heat
of the cookware.
4.4 Timer
Count Down Timer
You can use this function to set how long
the roasting zone should operate for a
single cooking session.
First set the roasting zone then set the
function. The selection of the Timer
function is possible for roasting zones
that are active and after the temperature
is set.
To set the roasting zone: touch
again and again until the indicator of a
necessary roasting zone comes on. When
this function is active,
To activate the function: touch
the timer to set the time (00 - 99
minutes). When the indicator of the
roasting zone starts to flash slowly the
time counts down.
To see the remaining time: set the
roasting zone with
the roasting zone starts to flash quickly.
The display shows the remaining time.
To change the time: set the roasting
zone with
. Touch
To deactivate the function: set the
roasting zone with
ENGLISH
9
comes on.
of
. The indicator of
or
.
and touch
.
Publicité
Chapitres
Table des Matières
