Publicité
Les langues disponibles
Les langues disponibles
retailer or an LGB service station
(see Authorized Service).
Hint: If this model is equipped
with a decoder, the digital/analog
DIP switches on the loco circuit
board must be set to OFF. The
DIP switches should remain in
this setting, even if the model is
used on an analog layout.
Attention! After extended opera-
tion, this model may leave carbon
dust or other debris around the
track. This dust and debris can
stain carpet and other materials.
Consider this when setting up
your layout. Ernst Paul Lehmann
Patentwerk and LGB of America
are not liable for any damages.
SERVICE
Do-It-Yourself Service Levels
Level
- Beginner
Level
- Intermediate
Level
- Advanced
Attention! Improper service will
void your warranty. For quality
service, contact your authorized
retailer or an LGB factory service
station (see Authorized Service).
Lubrication
The axle bearings and the side
rod ends should be lubricated
occasionally with a small amount
of LGB Maintenance Oil (50019).
Cleaning
This model can be cleaned exter-
nally using a mild detergent and
gentle stream of water. Do not
immerse this model.
Attention!
equipped with sound electronics.
Do not expose the speaker direct-
ly to water.
Replacing the light bulbs
Front lantern: Carefully pull the
cable and light bulb out of the
lantern.
Replace
Reassemble.
Rear lantern: Carefully pry the
lens away from the lantern. Using
tweezers, remove and replace the
bulb. Reassemble.
Cab
light:
remove and replace the bulb.
8
This
model
the
Using
tweezers,
Replacing the
smoke generator
- Pull the safety cover out of the
smoke stack (Fig. 4).
- Use pliers or tweezers to pull the
old smoke generator out of the
stack (Fig. 5).
- Cut the wires to the old genera-
tor and attach them to the
replacement generator (Fig. 6).
- Insulate the connections and
push the replacement generator
into the stack.
- Reassemble.
Replacing the traction tire
- Remove the two hex head
screws that attach the side rods
to the rear wheels.
- Remove the side rods from the
rear wheels.
- Use a small, straight-blade
screwdriver to replace the trac-
tion tire:
- Pry the old traction tire out of the
wheel groove.
- Gently insert the new traction
tire into the wheel groove.
- Make sure that the traction tire is
seated properly in the wheel
groove.
Maintenance parts
50010 Smoke
50019 Maintenance Oil
51020 Gear Lubricant
55020 MTS Decoder
62201 Standard
63120 Brushes, Assembled,
is
63218 Standard Pick-Up
65853 Smoke Generator, 5 V
68511 Plug-In Bulb, Clear, 5 V,
69104 Traction Tire, 37.5 mm,
bulb.
AUTHORIZED SERVICE
Improper service will void your
warranty. For quality service, con-
tact your authorized retailer or
one of the following LGB factory
service stations:
and
Fluid
Motor
Short Shaft
14 mm and 16 mm,
8 pieces (3 sets required)
Shoes, 2 pieces
10 pieces
10 pieces
Cleaning
with
Publicité
