Troubleshooting - Skil 7510 Guide D'utilisation

TROUBLE SHOOTING
WARNING
Problem
Tool will not start 1. Power cord is not plugged in.
Tool does not
come up to
speed
Read instruction manual first! Remove plug from the power source before
making adjustments or assembling accessories.
Cause
2. Power source fuse or circuit
breaker tripped.
3. Cord damaged.
4. Burned out switch.
1. Extension cord has insufficient
gauge or is too long.
2. Low house voltage.
Remedy
1. Plug tool into power source.
2. Replace fuse or reset tripped circuit
breaker. (If the product repeatedly causes
the circuit or fuse to trip/blow, discontinue
use immediately and have it serviced by an
Authorized Skil Service Center or Service
Station.)
3. Inspect cord for damage. If damaged,
have cord replaced by an Authorized Skil
Service Center or Service Station.
4. Have switch replaced by an Authorized
Skil Service Center or Service Station.
1. Replace with adequate extension cord
(Page 18).
2. Contact your electric company.
19