Transport; Storage; Maintenance - Scheppach HS410 Traduction Des Instructions D'origine

Clean the equipment regularly with a damp cloth and
some soft soap. Do not use cleaning agents or sol-
vents; these may be aggressive to the plastic parts in
the equipment. Ensure that no water can get into the
interior of the equipment.

12. Transport

Place the jack in the transport position and secure it
with the locking lever.
Because this saw does not have any transport
wheels, there is no option to transport the saw on
your own. Two people are required for transportation.
Hold the saw only by the bottom frame as otherwise
there is a risk of some parts of the swivel log saw
shifting out of place

13. Storage

Store the device and its accessories in a dark, dry
and frost-proof place that is inaccessible to children.
The optimum storage temperature is between 5 and
30˚C.
Cover the electrical tool in order to protect it from
dust and moisture.
Store the operating manual with the electrical tool.

14. Maintenance

Attention!
Pull out the power plug before carrying out any main-
tenance work on the equipment.
Connections and repairs
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Change of saw blades (Fig. 22 - 27)
1. Unplug the unit.
2. Wait until the blade stops rotating and the motor
has cooled down.
3. Bring the jack into the transport position and lock
the saw in this position with the locking lever.
4. Remove the guard (17)
5. Loosen the nuts (I2) on the guide (17a)
6. Now push the guide (17a) out of the threaded pin.
7. Loosen the chain (12)
8. Remove the spring split pin (17a) from the recoil
spring (11).
9. Loosen the locking lever and grasp the jack firmly
so that it does not fall down and the recoil spring
cannot jump out of the unit in an uncontrolled
fashion.
10. Tip the jack carefully back and place it on the
ground. (Fig. 24)
11. Remove the outer saw blade guard (14) (fig. 25)
12. Loosen the hex nut (G) with the installation tool
(25) provided (fig. 26)
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
13. Remove the outer flange (22)
14. Carefully remove the saw blade. Wear protective
gloves for this part of the work. (Attention: there is
danger of injury, so please take caution!)
15. Before replacing the saw flange, clean the flange
with a cloth or soft brush.
16. Replace the saw blade and flange and tighten the
hex nut (G).
17. Reassemble the device in reverse order.
18. Test the functionality of the rocker.
ATTENTION ! Observe the correct direction of rota-
tion when inserting the saw blade.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the
following parts are therefore also required for use
as consumables.
Wear parts*: sawblade, rocker inlet
* Not necessarily included in the scope of delivery!
GB | 27