Factory Setting; Load Curve - Cristec UECPS3/12–16/2D Manuel D'utilisation

3.3.3 Factory setting

The shore-power unit's factory settings are:
Sealed type battery (sealed lead) (see table above)
BOOST activated
The installer should set the selection wheel (RC1) (excluding input and off-load output voltage) and possibly
adjust the output voltage using potentiometer RV1 (use the appropriate tool to turn the screw of the
potentiometer), depending on:
- the type of battery (contact the battery manufacturer if necessary)
- the intended usage
- the cross-section and length of the output cables
- whether or not the boost function is required
For special batteries, call in a professional installer, who will make the specific settings in accordance with
the accumulator manufacturer's specifications and according to the specifics of the installation.
CRISTEC disclaims any liability in case of damage to batteries or ineffective recharging.

3.3.4 Load curve

Boost activated
With this setting the CPS3 shore-power unit produces a 3-state load curve IUoU: Boost, Absorption, Floating.
U out
charger
Boost
U boost
0
I out
charger
Boost
I nom
0
U boost:
U floating:
T boost:
UECPS3-12-16/25/40-DEA.DOC
Flat battery
Absorption Floating
U floating
Tboost
t
Absorption Floating
Tboost
t
BOOST voltage (see table above)
Floating voltage (see table above: voltage with no BOOST)
BOOST maximum duration (see table above)
Battery only slightly flat
U out
charger
Boost Absorption
U boost
U floating
< Tboost
0
I out
charger
Boost Absorption
I nom
15% I nom
15% I nom
< Tboost
0
Floating
t
Floating
t
25