Trevi XT 104 BT Mode D'emploi Et Branchement page 9

ENGLISH
NOTES ON USE
This is a precision electronic appliance; avoid using it in the following cases:
• Place the device on a flat surface.
• Place the device so that its sides there is always enough space for air to circulate freely (at least 10 cm).
• Do not place anything on top of the unit.
• The apparatus shall not be exposed to dripping or splashing water. No objects filled with liquid, such as vases,
should be placed on the unit.
• If liquids penetrate inside the device immediately disconnect the plug from the socket and take it to the nearest
service center autorizato TREVI.
• No naked flame sources, such as lighted candles, should be placed on.
• Cables should be hidden and protected in order to avoid stumbling from someone and the consequent fall of the
appliance.
• Keep the unit away from the following places:
near magnetic fields;
near heat sources (radiators, stoves, direct sunlight, etc...);
near wetlands (bathrooms, swimming pools, etc...);
dusty areas; areas subject to strong vibration.
• Disconnect the power cord during storms or for long periods of inoperation.
• Unplug the power cable during thunderstorms or long periods of inactivity.
• Instruct the proper use children and people with little knowledge of the product.
• Do not close the ear to the loudspeaker during step setting and volume adjustments, and in particular keep the
volume at idle during power-up.
• Listen at high volume for a long time, can damage your hearing.
• Keep the following user manual.
To prevent possible hearing damage, do not listen at high volumes levels for long periods.
CARE AND MAINTENANCE
Use a slightly damp soft cloth for cleaning. Do not use solvents and abrasive substances.
IMPORTANT
This appliance has been carefully built to ensure long-lasting perfect performance. However, should any inconvenience
occur, please contact your local authorised TREVI Service Centre.
TREVI follows a policy of ongoing research and development. Therefore products may have different features from
those described.
INSTALLATION
1. Rotate the tower and locate the holes (in the opposite side of the keyboard);
2. Fit the base with the body aligning the holes on the base with the holes on
the tower;
3. Screws the base into the body;
4. Do not over tighten the screws to avoid damaging the cabinet;
5. Place the speaker standing on the floor and it's ready to use.
9
XT 104 BT