Transport - B+B Pyro Light Optima Mode D'emploi

Pyro Light Optima
| Leichtgewichtrollstuhl
Pyro Light Optima XL

8. Transport

8.1. Transporting the wheelchair
In order to make the wheelchair as manageable as possible to
transport, remove all removable parts (legrests, drive wheels, armrests,
loose accessories) and fold the wheelchair up (see Chapter 4.1).
A
8.2. Transportation in vehicles
To see whether your wheelchair is permitted for use as a seat in a
Vehicle for Transporting Individuals with Impaired Mobility or not, you
can refer to the sticker next to the identification label on the wheelchair.
• Wheelchair is designed for use as a seat in a Vehicle for
Transporting Individuals with Impaired Mobility (Fig. A).
• Wheelchair is not designed for use as a seat in a Vehicle for
Transporting Individuals with Impaired Mobility (Fig. B)
If your wheelchair is not designed to be used as a seat in a vehicle,
B
under no circumstances must it be used as such. It does not fulfil the
requirements in compliance with ISO 7176-19. Violation can cause the
most serious injuries resulting in death in the case of an accident
(Fig. B).
All products approved by Bischoff & Bischoff as seats in vehicles are
tested according to ISO 7176-19. The tests according to ISO 7176-19
were carried out with the restraint systems of AMF-Bruns.
With the installation of a restraint system, the wheelchair can be used
as a vehicle seat.
The correct assembly of the restraint system is a prerequisite for the
safe transport of the products in the motor vehicle for the transport of
mobility impaired persons (VMP) and the basis for the release. Fixing
points on the restraint system (Fig. A).
The restraint systems of AMF-Bruns provide the force nodes (Fig. A)
for fixing the products in the VMP. The products may only be attached
to these force node points for restraint in the VMP. If possible, use a
permanently installed car seat and its belt system. Stow the wheelchair
in the load compartment. The person responsible for the transport
should be familiar with the current regulations for transport and with
the operation of the VMP and the restraint system. Four-point restraint
80 80
Leichtgewichtrollstuhl |
systems anchored to the vehicle must be used to secure the wheelchair.
If your wheelchair is not crash-tested, under no
circumstances must it be used as a vehicle seat in
a vehicle for transporting individuals with impaired
mobility. There is a risk of death!
9. Maintenance instructions for the
user
9.1. Cleaning and disinfection
• Wipe the frame parts of the wheelchair with a damp cloth. If there
is heavy contamination, also use a mild cleaner.
• Clean the wheels with a damp brush with plastic bristles (do not
use a wire brush).
• Wash the push handles, armpad, seat and back cushion with a mild
cleaner.
• For disinfection use a disinfectant listed by the Association for
Applied Hygiene.
• Upholstery parts may be machine washed at 40°C. Do not
machine dry, dry at room temperature only.
9.2. Checks before driving
9.2.1. Checking the brakes
Before setting off each time, check that the brakes work properly.
With the parking brakes applied, the wheelchair cannot be pushed
on dry surfaces. When the brakes are released, the wheelchair runs
without scraping noises and good directional stability.
If this is not the case, notify your dealer immediately and stop using the
product until it has been serviced.
Bischoff & Bischoff GmbH |2022-03-18 - Revision: 2
Pyro Light Optima
Pyro Light Optima XL
81 81