Télécharger Imprimer la page

Burkert 6144 Manuel D'utilisation page 4

Masquer les pouces Voir aussi pour 6144:

Publicité

Les langues disponibles

Les langues disponibles

8.
ASSEMBLY
8.1. Safety instructions
WARNING!
Assembly work may result in hazardous situations.
• Such work may only be performed by persons with
appropriate technical knowledge and using suitable
tools!
• After an interruption of the electricity or the compressed
air supply, ensure that the process is started up again in
a defined or controlled manner!
Danger from unintentional activation of the system!
Unintentional start-up of the system may lead to injuries
and property damage.
• Use suitable means to prevent the system from being
activated unintentionally.
8.1.1.
Devices which are designed for
use in zone 2/22
The user must ensure that this unit complies with the
degree of protection IP54 in accordance with EN 60529.
For example, by installing it in a suitable housing.
english
12
Assembly of Type 6144 with Bürkert flange:
(see Figure 1: Assembly drawing for Bürkert flange)
WARNING!
Danger of escaping fluids!
Connections will leak if the seal is not properly seated.
• Ensure that the supplied sealing mat is correctly seated.
Insert sealing mat into the valve.
Assign fluids 1, 2 and 3 correctly on the valve and con-
nection plate.
Drill holes in accordance with hole pattern.
Screw valve to connection plate
Check valve for proper seal
Assembly of Type 6144 with lateral flange:
(see Figure 2: Assembly drawing for lateral flange)
Assign fluids 1, 2 and 3 correctly on the valve and con-
nection plate.
Drill holes in accordance with hole pattern.
Screw valve to connection plate
Check valve for proper seal
english
14
8.2. Fluid installations
WARNING!
Danger of injury from high pressure.
• Before detaching lines and valves, cut off pressure and
vent!
Risk of injury due to malfunction/escape of medium.
If the exhaust air from other processes is used to gen-
erate compressed air for the device, the seals may be
destroyed by the media contained in the air.
• Use only fresh air to generate compressed air for the
device.
Important operating conditions to avoid
malfunctions:
The valve must be at least 5 mm away from other
ferromagnetic materials.
Installation position:
any, preferably with the drive
upwards.
Before assembly:
Clean pipes and flange connections.
To protect against malfunctions, install a filter (5 µm)
upstream of the valve.
Valve with fastening elements
Sealing mat:
Connection
plate
Fig. 1:
Assembly drawing for Bürkert flange
Fastening
screws
Hole pattern:
ø 1.6 (max.)
M1.6
1
2
3
6.4
Fig. 2:
Assembly drawing for lateral flange (FS09)
Type 6144
english
13
Hole pattern:
4
4
M1.6
ø 2.0 (max.)
3
2
1
21.5
Valve with
fastening
elements
Sealing mat:
english
15

Publicité

loading