Fortress Building Products PURE VIEW Instructions D'installation page 39

Fig. 3
STAIR BRACKET: CUTTING DOWN TOP & BOTTOM RAILS
Step 1: Measure & Mark Rails Where Cuts Will Be Made
1. Position support blocks on stairs in line with bottom brackets.
2. Place bottom rail on top of support blocks next to
bottom brackets. Have bottom rail positioned as close to final
installation position as possible.
3. Add two balusters to the bottom rail, add top rail then clamp
panel to post. As shown in Fig. 1.
4. Measure spacing from inside edge of post to the baluster
space. Spacing CANNOT exceed 4"[101.5mm] on each end.
As shown in Fig. 2.
5. Place cut marking on rails in line with the back of bracket
opening. Be sure bottom of bracket and bottom of rail are
flush. As shown in Fig. 2.
6. Use speed square to ensure markings are perpendicular to
panel.
Clamp
Fig. 1
Balusters
Support
Blocks
PURE VIEW: Al
Fig. 2
Clamp
HOME GLASS BALUSTER INSTALLATION
13
Mark on rail
from back
of bracket
Post To Baluster
Space Must Be
Less Than 4"
[101.5mm]
39