Fortress Building Products PURE VIEW Instructions D'installation page 19

Fig. 1 Spacer Attached
Next To Bracket
Fig. 2
Double Sided
Step 2. Round ATR Line & End
1. Measure the distance from the inside edge of the 2 posts.
2. Cut the ATR to measured length.
3. The ATR cannot block the inside edge of the post. As shown
in Fig. 3.
4. When test fitting the ATR, place on top of the spacers. Do
not press the ATR down over the spacers. Removing the
ATR from the spacers can damage the ATR and spacers. As
shown in Fig. 2.
5. Remove the backing of all of the double-sided tape on the
ATR spacers.
6. A Rubber Mallet might need to be used to install. If using a
rubber mallet, use a cloth to protect the ATR from damage.
PURE VIEW: Al
14" [279.5mm]
Max
Tape
HOME GLASS BALUSTER INSTALLATION
13
19