Stihl RMA 339 Manuel D'utilisation page 59

RMA 339.0
Measurement in accordance with
EN 20643
RMA 339.0 C
Length 135 cm
Width 43 cm
Height 110 cm
Weight (without
battery) 16 kg
Hand-arm vibrations:
Specified vibration characteristic in
accordance with EN 12096:
Measured value a 1,60 m/sec
hw
Uncertainty K 0,80 m/sec
hw
Measurement in accordance with
EN 20643
19.1 STIHL AK battery
Battery technology Lithium-ion
Voltage 36 V
Capacity in Ah See rating plate
Energy content in
Wh See rating plate
Weight in kg See rating plate
Permissible tempera-
ture range -10°C to +50°C
This symbol indicates the
number of cells and the energy
content according to the cell
manufacturer's specifications.
The available energy content is
lower in practice.
0478 131 9927 C - EN
19.2 REACH
REACH is an EC Directive for the
registration, evaluation, authorisation and
restriction of chemicals.
Information on compliance with the
REACH Directive (EC) No. 1907/2006 is
available from www.stihl.com/reach.
20. Troubleshooting
If necessary, contact a specialist
dealer; STIHL recommends STIHL
2
specialist dealers.
2
Fault:
Motor not starting
Possible cause:
– Battery charge state too low – 1 LED
flashes green on battery
– Battery too cold/too warm – 1 LED
illuminates red on battery
– Battery fault – 4 LEDs flash red on
battery
– Lawn mower is too warm – 3 LEDs
illuminate red on battery
– Lawn mower fault – 3 LEDs flash red on
battery
– ON button not pressed
– Safety plug is not inserted
– Electrical connection interrupted
between lawn mower and battery
– Motor is overloaded because grass is
too tall or too wet
– Humidity in machine and/or battery
– Mower housing is blocked
– Fuse in safety plug is defective
Remedy:
– Recharge battery (
– Warm up battery or allow it to cool down
– Remove and re-insert battery; consult
specialist dealer if necessary ( )
– Allow lawn mower to cool down
– Clean electric contacts in battery
compartment (
specialist dealer if necessary ( )
– Press ON button (
– Insert safety plug (
– Insert battery correctly (
electric contacts in battery
compartment (
– Do not switch on motor in high grass,
adapt cutting height (
– Remove battery and dry; clean and/or
dry battery compartment (
– Clean mower housing (
– Replace safety plug ( )
Fault:
Motor stops during operation
Possible cause:
– lawn mower overheated – 3 LEDs
illuminate red on battery
– Electrical fault
– Safety plug incorrectly inserted
– Machine overloaded due to mowing
grass that is too long or too wet
– Lawn mower fault
Remedy:
– Allow lawn mower to cool down
– Remove and re-insert battery (
– Insert safety plug (
– Adapt cutting height and mowing speed
to mowing conditions (
– Repair lawn mower ( )
Fault:
Excessive vibration during operation
Possible cause:
– Blade fastening screw is loose
8.4)
13.2); consult
12.2)
9.2)
8.3); clean
13.2)
9.6)
8.3)
13.2)
8.3)
9.2)
9.6)
57