Nolan N40 Sécurité Et Instructions D'utilisation page 16

N40 OK_N104 0072 14/01/14 16.07 Pagina 16
- Do not remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please refer to a Nolan
authorized dealer.
VISOR
5. Visor Disassembly
To disassemble the visor first remove the lateral latches and (if assembled) the peak
- see instructions above.
5.1. Open the visor completely (Fig. 7).
5.2. Push the release lever of the left side mechanism completely upwards moving
it over the side trim (Fig. 8) and pull the visor away from the helmet (Fig. 9).
5.3. Release the release lever and replace it downwards in its original position
moving it over side trim.
5.4. Follow the same steps on the right side of the helmet.
6. Visor Assembly
6.1. Place the left side of the visor on the corresponding side mechanism centring
the side hole of the visor on the mechanism itself (Fig. 9).
6.2. Push the release lever of the mechanism completely upwards moving it over
the side trim and press the visor against the side mechanism (Fig. 8, 9).
6.3. Disengage the release lever and replace it downwards in its original position
moving it over the side trim. Then check that the visor remains attached to the
mechanism by pulling it outwards.
6.4. Follow the same steps on the right side of the helmet.
6.5. If desired, replace the peak above the visor, and finally always replace both
lateral latches (see instructions above).
6.6. Close the visor completely.
WARNING
- Make sure that the mechanisms are working properly. Open and close the visor
making sure that the mechanisms hold it in the different positions.
If necessary, repeat the above-mentioned steps.
- If the peak is assembled over the visor check the proper functioning as descri-
bed previously.
- Do not use the helmet if the visor and the lateral latches have not been assem-
bled properly.
- Do not remove the side mechanisms from the shell.
- Should any of the side mechanisms fail or be damaged, please refer to a Nolan
authorized dealer.
SIDE PLATES
When the helmet N40 is configured without the visor the side plates must be assem-
bled in its place.
16