Oase Water Jet Lightning Notice D'emploi page 17

Maintenance and cleaning
Prior to starting work on the units, disconnect the power plugs of all units in the water (J)!
Cleaning the Water Jet Lightning (N, O)
– Separate the upper section (34) from the housing bottom section (36) with a slight twist, then remove together
with the O-ring (35) .
– Remove the foam filter (37) and unscrew the LED unit (38) .
– Clean all parts under running water using a soft brush.
– Squeeze out the foam filter (37) several times under running water.
Cleaning the pump (D, P)
– Loosen the union nut (14) at the Y distributor (15).
– Unscrew the reduction piece (16) from the pump (4) and remove the Y distributor (15).
– Pull the motor housing (39) out of the engagement holder of the plug-in filter (40).
– Remove the pump housing (41) with a slight turn, and remove the impeller (42) .
– Clean all parts under running water using a soft brush.
Unit reassembly (N, O, D, P)
– Reassemble the units in the reverse order.
Battery change in the manual transmitter (Q, R)
Improper treatment can lead to damage of the manual transmitter!
– Touch an uncoated metal surface (e.g. radiator) to discharge static charges that could lead to damage
to the internal components of the manual transmitter!
– Prevent the ingress of dirt and humidity into the manual transmitter!
– Insert a screwdriver (43) into the lateral opening (44) of the manual transmitter.
– Open the housing of the manual transmitter by slightly turning the screwdriver, then remove the housing bottom
section (45).
– Pull the battery (46) out of the holder (47).
– Push the new battery (type CR 2032) into the holder (47). Ensure that the embossed side (48) of the battery
points upward.
Wear parts
· Impeller unit
· Bulb
Spare parts
The use of original parts from OASE ensures continued
safe and reliable operation of the unit.
Please visit our website for spare parts drawings and spare
parts.
www.oase-livingwater.com/spareparts
- EN -
17