Fitting The Rechargeable Battery; Removing The Rechargeable Battery; Chip Extraction; Saw Blade Selection - Mafell KSS40 18 M bl Traduction De La Notice D'emploi Originale

Follow the instructions for the
protection of the environment.

4.2 Fitting the rechargeable battery

Slide the charged rechargeable battery into the
battery guide behind the handle until it perceptibly
engages.
Before using the machine,
convince yourself that the
rechargeable battery is firmly
seated in the machine.

4.3 Removing the rechargeable battery

Unlock the rechargeable battery by pressing the
locking lever 1 (Fig. 3) and pull it out of the battery
guide.
Do not use force to do so.

4.4 Chip extraction

Connect the machine to a suitable external dust
extractor during all work generating a considerable
amount of dust. The air velocity must be at least 20
m/s (65.6 ft / sec.).
The internal diameter of hose connector 3 (Fig. 3) is
28 mm (1 7/64 in.).

4.5 Saw blade selection

Use a sharp tool to obtain a good cut quality and
select a tool from the following list according to
material and application:
For cuts along and across the grain in soft or
hard wood:
- Circular saw blade carbide Ø 120 x 1.8 x 20 mm (4
¾ x 5/64 in. x 20 mm), 24 teeth
For cuts especially along the grain in soft or hard
wood:
- Circular saw blade carbide Ø 120 x 1.8 x 20 mm (4
¾ x 5/64 in. x 20 mm), 12 teeth
For cuts especially across the grain in soft or
hard wood:
- Circular saw blade carbide Ø 120 x 1.8 x 20 mm (4
¾ x 5/64 in. x 20 mm), 40 teeth
For cuts in laminate:
- Circular saw blade carbide Ø 120 x 1.8 x 20 mm (4
¾ x 5/64 in. x 20 mm), 40 trapezoidal teeth
Order No. see special accessories.

4.6 Saw blade change

Danger
Unplug the rechargeable battery for
all service work.

Press the locking bolt 8 (Fig. 2).

Using the Allen-key 3 (brackets Fig. 1), unfasten
the flange screw 8 (Fig. 3) counter clockwise;
remove the screw as well as the front clamping
flange 7.

Now you can remove the saw blade after
opening the retractable saw guard 9.

The clamping flanges must be free of adhering
parts.

Pay attention to the sense of rotation when
inserting the saw blade.

Afterwards, mount the clamping flange, attach
the flange screw and tighten it by clockwise
turning.

In doing so, keep the locking bolt depressed.

4.7 Riving knife/splitter

Danger
Unplug the rechargeable battery for
all service work.
The riving knife / splitter 6 (Fig. 3) prevents the saw
blade from jamming during longitudinal cutting. The
correct distance to the saw blade is shown in (Fig. 8).

For adjustment, unfasten the screw 4 (Fig. 3)
with the Allen-key supplied with the saw 3 (Fig.
1).

Adjust the riving knife/splitter by shifting it in its
longitudinal slit. Afterwards retighten the screw.
-26-