Working With Guide Rail; Working With Position Indicator; Removing / Fitting Onto Kss Rail; Service And Maintenance - Mafell MF 26 cc Traduction De La Notice D'emploi Originale

5.12 Working with guide rail


Place the machine onto the guide rail such that
the groove 24 (Fig. 6) of the base plate rests
above the spring and is guided by it.

Set the cutting depth indicator 10 (Fig. 8) into
the top position by turning (with rail). Thus, the
scale can also be used with the rail.

5.13 Working with position indicator

Use the position indicator to align
the guide rail to a centre marking of
the guide groove. It is included with
the machine or tools (for
plasterboard milling cutter and
aluminium compound milling
cutter).
Proceed as follows:

Fit the position indicator 42 (Fig. 6) onto the rib
of the guide rail.

Move the position indicator on the rail up to the
marking.

Move the rail with position indicator until the
front (red edge) of the marking indicator agrees
with the marking.

Place the machine onto the rail (the tool is now
aligned with the centre of the marking).

Set the required milling depth and machine the
workpiece.

5.14 Removing / fitting onto KSS rail

Remove:

Slide the machine forward on the rail by 2-3 cm
(25/32 – 1 3/16 in.).

Actuate the ratchet 41 (Fig. 5) and pull the
machine to the rear out of the guide rail.
Attaching:

Place the machine onto the guide rail in the rear
guide rail area such that the groove 24 (Fig. 6)
on the front of the base plate agrees with the
spring of the guide rail (overlap on the left-hand
base plate side approx. 5 - 10 mm, 13/64 –
25/64 in.).

Slide the machine forward until the ratchet
engages behind the base plate.
6

Service and maintenance

Danger
Pull the power plug during all
service work.
MAFELL machines are designed to be low in
maintenance.
The ball bearings used are greased for life. When the
machine has been in operation for a longer period of
time, we recommend to hand the machine in at an
authorised MAFELL customer service shop for
inspection.
Only use our special grease, order No. 049040 (1 kg
tin) for all greasing points.

6.1 Storage

If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
-31-