Sony KL-X9200J Mode D'emploi page 18

Eliminating flickering or blurring (DOT
ADJUST)
MENU
If a part of the screen is flickering or blurring, adjust
PITCH and PHASE in the DOT ADJUST menu.
1
Load the Utility Disk (supplied) into your
computer.
2
Press MENU.
MENU
3
Press v or V to select "
and press ENTER.
4
Press v or V to select PITCH, and press
ENTER.
The PITCH adjustment screen appears.
5
Press v, V, B or b until the lines on the
screen become uniform.
Adjust the vertical lines on the screen so that they
are evenly spaced.
18 -GB
Operations
ENTER
(DOT ADJUST),"
D O T A D J U S T
PHASE
PITCH
ENTER
TIMING
EX I T
ENTER
PITCH
6
Press ENTER.
The DOT ADJUST menu appears.
If notches in the vertical lines or horizontal noise is
observed over the entire screen, adjust PHASE in
the next step.
7
Press v or V to select PHASE, and press
ENTER.
The PHASE adjustment screen appears.
8
Press v, V, B or b until the screen becomes
uniform.
Adjust to diminish the notches in the vertical lines
or the horizontal noise on the picture.
7
0
YES
Using the Utility Disk
The supplied Utility Disk contains test patterns for
– 6
PITCH and PHASE adjustments. These test patterns
will help you confirm that your adjustments are
correct.
If TIMING is set to NO in the DOT ADJUST menu
1 Press v or V to select TIMING, and press ENTER.
The TIMING adjustment screen appears.
2
Press v, V, B or b until TIMING is set to YES.
The PITCH, PHASE or TIMING adjustment screen
automatically disappears after about 80 seconds if you
do not press any button.
You can also erase the screen by pressing MENU again.
Note
You cannot use this function for the input from VIDEO 1/2/3 IN
and COMPONENT IN.
ENTER
ENTER
PHASE
7