Conrad Electronic KeyMatic KM300RI Notice D'emploi page 32

Warning!
Never connect button connections with the power supply! It
can cause perilous electric shock danger!
• For the connection between interface and doorlock actuator use the cord set
included in the delivery.
• Install the cable selectively on or in the door or/and along the sealing of the
door.
Make sure that the cable is neither jammed nor twisted and that
it is not mechanically loaded in any way. Place it so as to prevent
people from tripping over it or from being disturbed by it in any way.
• Open the battery compartment of the doorlock actuator and remove the
inserted batteries.
Never connect the connecting cable or the mains unit if
batteries are inserted in the doorlock actuator.
There is a risk of explosion, fire and injuries!
• Connect the plug of the connecting cable included in the delivery to the 4-
pole jack of the doorlock actuator (the small 2-pole connection on the
doorlock actuator is meant to be connected to a signal lamp).
A Connection for signal lamp
B Charge-control LED
C Connection for Interface "KM300RI"
Warning!
The connectors are pluggable in one direction only via noses and
slots. Do not use force when plugging-in!
32
A B C