Special Safety Instructions - Rothenberger RP PRO III Instructions D'utilisation

1.6

Special safety instructions

This document contains important instructions for people's safety. It is intended for the user. Keep it in
a safe place for future reference.
Read and follow these instructions closely every time that the test power pump is turned on:
1. Ensure that the electrical system has an appropriate RCD circuit-breaker.
2. Always disconnect the power pump after each test and before carrying out the following operations:
a. Moving the power pump from one position to another.
b. For maintenance.
c. For accessory and part replacement.
3. Do not pull on the electric cord, on the supply hose or on the high pressure hose connected to the
piping system to move the power pump.
4. Never pull on the electrical supply cord to unplug it.
5. Never let unqualified people, children, adolescents, etc. or people who are not trained in the use
of power pumps use the pump.
6. To guarantee the safety of the power pump, follow the manufacturer's instructions and only use
original replacement parts, components and accessories or parts which have been authorised by
the manufacturer.
7. Water nozzles can be very dangerous if used inappropriately: never point the water jet at people,
animals, electrical equipment or the power pump itself.
8. Never use the water jet on yourself or other people to clean clothing or shoes.
!
9. ATTENTION: the hoses, accessories and couplings are very important for the safety of
the power pump. Only use hoses, accessories and couplings which are recommended by the
manufacturer.
10. Never use the power pump when the electrical supply cord or other important parts such as safety
devices, high pressure hose, etc. are damaged.
11. If you have to use an extension cord, the plug and connector must be waterproof.
12. Inappropriate extension cords can be dangerous.
13. The user must take all of the safety precautions mentioned in this manual into consideration.
Otherwise, misuse of the equipment can cause accidents and the manufacturer assumes no
responsibility if this is due to the disregard of the safety precautions mentioned here.
Do not dispose of electrical equipment with domestic waste. In compliance with the
Directive 2012/19/UE of the European Parliament and its transposition to the state
legislation framework in the Royal Decree 208/2005 on electrical and electronic devices
and the management of their waste, the objective is to prevent the generation of this
waste, to reduce its elimination and the level of danger of its components, to promote
the re-use of devices and the valorisation of their waste and determine a suitable way
to manage this in an aim to improve the efficiency of environmental protection.
ENGLISH 15