Velleman VL7198 Manuel D'utilisateur page 7

1. Power up the main unit and place the battery
pack into the battery mounting adaptor on the
charger.
2. The "CHARGER" LED will light up. Push the
DISCHARGE button. The "CHARGE3 LED
will go off, and the "DISCHARGE" LED will
light up. The charger will begin to analyse the
battery and will then start to discharge the
battery.
(Note: The user can push the discharge
button to switch between discharge and
charge mode during the charger's operation)
3. When the discharge of the battery pack is
completed, the charger will automatically
switch to CHARGE mode.
1. This mode is designed to be used
for batteries that have a serious
"memory effect". It is especially
useful for
batteries. If
battery's operating time has gone
down significantly, try to rescue
the battery by using this mode.
(Note: New batteries should also
be deep conditioned before use)
2. Power up the main unit and place
the battery pack into the battery
mounting adaptor on the charger.
3. When the "CHARGE" LED is on, push and hold down the DISCHARGE
button for at least five seconds. The "CHARGE" LED will go off, the
"DISCHARGE" LED will light up and the READY LED will flash three times
consecutively. You can then release the DISCHARGE button.
SMART CHARGER
THE DISCHARGE/CHARGE MODE
THE DEEP CONDITIONING MODE
recovering these
you think your
Push and hold until the READY
LED flashes, then release the
button.
7
Push to
switch
between
discharge
and charge
mode
VL7198