Velleman VL9798 Mode D'emploi

UNIVERSAL Ni-Cd & Ni-Mh BATTERY LOGIC PULSE FAST CHARGER
* It can charge 2 or 4 pcs AAA, AA, C & D batteries.
* Insert 2 or 4 pcs batteries into the charger, ensuring good contact and correct polarity (+)
and (-).
* Press START switch, the batteries discharge and the yellow LEDs lights up. (Fig. 1)
* When the discharge of batteries is finished. The batteries are changed to FAST charge
mode ; the yellow LEDs go off and the Red LEDs light up. (Fig. 2)
* After 2 hours the batteries are charged for 60 - 95% of their capacity. The charger will
then be changed to BOOST charge mode for the next 4 hours. The red LEDs go off and
the green LEDs light up. (Fig. 3)
* After 4 hours the batteries are charged for 100% of their capacity. The charger will then be
changed to TRICKLE mode for the continuity and the green LEDs are blinking. (Fig. 4)
* After a few hours of TRICKLE charge, the batteries are charged for more than 100% of
their capacities.
Push the START switch and plug in the AC outlet on same time. The charger will be tested
by itself. Discharge mode (yellow LEDs light up) → Fast charger mode (red LEDs light up)
→ Boost charge mode (green LEDs light up) → Trickle charge mode (green LEDs blink) →
Test finished.
After a few minutes of charging, push the START switch. If the batteries can't discharge, the
yellow LED will not light up continuously during 10 seconds. Then the battery is dead. Discard
it.
* For indoor use only
* Always remove mains plug from wall socket when not in use or before batteries are inserted.
* Covers should be only removed by a qualified electrician - this appliance contains
dangerous voltages
* Do not try to charge THROW AWAY batteries
* If the supply cord is damaged, it must be replaced by a qualified serviceman because
special tools are required.
OPERATING MANUAL VL9798
(WITH DISCHARGER & TIMERS)
OPERATIONS
CHARGE MODE TEST
TEST THE BATTERIES
WARNINGS