HQ Power PROMIX22U Notice D'emploi page 5

9. BAL Control
For a mono input to the L (MONO) input the function of the control is the same as the
PAN controls (5) of the mono channels. However, when a channel is run in stereo,
this control functions as a BALANCE control, determining the relative balance of the
left and right channel signals being sent to the left and right MASTER MIX buses. For
example, with the BALANCE control turned fully clockwise, only the right portion of
the channel's stereo signal will be routed to the MASTER MIX.
c. Master
10. STEREO Output
Use these jacks to connect to an external power amplifier if extra output power for a
larger PA system is required. The stereo outputs are left (L) and right (R) unbalanced
¼" TRS jacks, wired as tip = positive (+), sleeve = ground.
11. PHONES Output
The PHONES output will feed headphones and is a ¼" TRS jack, wired as tip = left
signal, ring = right signal, sleeve = ground.
12. TAPE Input
These jacks will accept the signal from an external device with a stereo output such
as a cassette recorder.
13. REC Output
The REC outputs also provide an output of the MASTER MIX. These outputs
are RCA jacks and designed primarily for inputs to tape recorders etc.
14. POWER ON LED
The red LED indicates that the console is powered on.
15. VU METER
The 4-stage LED VU meter displays the MASTER MIX output level.
16. MASTER MIX GAIN Control
The output level routed to the STEREO outputs and REC outputs is
determined by the MASTER MIX GAIN control.
17. TAPE/REC to PHONES Switch
Use the TAPE / ECHO TO PHONES switch to route signals from the TAPE
input (12) to the PHONES control (19).
18. TAPE/REC to MASTER Switch
Use the TAPE / ECHO TO MASTER switch to route signals from the TAPE
input (12) to the MASTER MIX GAIN control (16).
19. PHONES Control
The mixer allows you to monitor the MASTER MIX. The signal level is adjusted
with the PHONES control and routed to the PHONES (11) output.
d. Rear Panel
20. MAIN POWER Switch
This switches the mixer ON or OFF.
NOTE: Be sure to switch on the power to your mixer before switching on the amplification system.
21. AC POWER Input
Connect the enclosed power supply to the 3-pin mains connector on the rear of the console. Use the
included adapter to connect the console to the mains.
PROMIX22U_v2
5 HQPOWER