- Metallic objects reduce the range
due to the shielding effect of the
metal.
- Particularly in towns and cities,
there may be many other sources
of radio waves which can disrupt
the original signal.
- Having units operating at similar
frequencies located close to one
another may also result in mutual
interference.
Special aspects
• The alarm signal is repeated after
4 minutes (Autosnooze) unless
you press the Light/Snooze button
or the Wake-up alarm ON / OFF
button.
• The clock face illumination is also
activated when the alarm is trig-
gered.
• As well as the green marking of the
Alarm ON / OFF switch, the Snooze
button is also illuminated when the
alarm is triggered.
• You can select between two diffe-
rent alarm types. The alarm type is
altered as described below:
-- Switch off the alarm --
Press and hold the Snooze button
for 3 seconds.
-- Switch the alarm back on.
The Snooze button flashes to indi-
cate that the second alarm type has
been selected.
12 English
Maintenance and care
The lisa RF time flash does not
require any maintenance. If the unit
does become dirty, simply wipe it
clean with a soft, damp cloth. Never
use spirits, thinners or other organic
solvents. Do not set up the llisa RF
time flash where it will be exposed
to full sunlight for long periods. In
addition, it must be protected
against excessive heat, moisture and
severe mechanical shocks.
Note: This product is not protected
against splash water. Do not place
any containers filled with water,
such as flower vases, or anything
with an open flame, such as a lit
candle, on or near the product.
Warranty
The lisa RF time flash is a very relia-
ble product. Should a malfunction
occur despite the unit having been
set up and operated correctly, please
contact your dealer or the manufac-
turer directly. This warranty covers
the repair of the product and retur-
ning it to you free of charge during
the warranty period. It is essential
that you send in the product in its
original packaging, so do not throw
the packaging away. The warranty
does not apply to damage caused by
incorrect handling or attempts to
repair the unit by people not authori-
zed to do so (do not break the seal
on the unit).