Publicité
Les langues disponibles
Les langues disponibles
plied from the factory, the lisa RF time
flash is set to channel 0. It is only ne-
cessary to set units to other channels if
you have several different users opera-
ting units in the same building. Set the
channel you want by adjusting the channel selector switch on the underside
of the unit to the required channel number. Use a small screwdriver to adjust
this switch. All transmitters and receivers within your system must be set to
the same channel.
Transmission Signal Recognition
The lisa RF time flash converts the various transmission signals into
varying sequences of flash and signal displays.
Telephone:
Telephone LED lights
Flashing-
sequence
Doorbell I:
Doorbell LED lights
Flashing-
sequence
Doorbell II:
Doorbell LED flashes
Flashing -
sequence
Babymonitor: Baby Monitor LED lights
Flashing -
sequence
Pager:
Pager LED lights
Flashing -
sequence
Alarm:
All LEDs flash
Flashing -
sequence
10 English
Publicité
