hergom MANCHESTER Mode D'emploi page 41

11 - MAINTENANCE
CHANGING THE GLASS PANE
WARNING! DO NOT USE THIS PRODUCT
WITHOUT THE GLASS PANE OR WITH A BROKEN
OR CRACKED PANE. DO NOT FORCE THE DOOR,
FOR EXAMPLE, KNOCKING IT OR SLAMMING
IT. THE GLASS PANE MUST ONLY BE CHANGED
BY QUALIFIED SERVICE PERSONNEL.
1. Follow the instructions included with the glass
replacement kit.
2. Remove the door.
3. Remove the screws holding the glass fixing
clips (use penetrating oil if necessary) - remove
the glass fixing clips upward. Set them aside for
the new installation.
4. Carefully lift the damaged glass, removing it
from the door and discard.
5. Carefully remove the remains of any old glass
and seal.
Glass seal
Ceramic seal
door seal
Cast Iron Door
6. Clean the screw holes and put a small amount
of lubricant in each.
7. Place the new glass and seal in the door.
8. Important! Center the glass and make sure the
edges are parallel with the edges of the door.
9. Recheck the position of the glass (centred and
parallel), then screw the fixing clips (diagonal
cross system) to the door. Tighten the screws
no more than 1/4 turn. If the glass is not
positioned correctly, it will break.
10. Apply a thin film of lubricant on the hinges of
the door, if necessary.
11. Install the door.
12. After lighting the stove 5 or 6 times, check
the screws holding the glass fixing clips and
readjust if necessary.
ASSEMBLING THE FRONT DOOR
41
Fixing Clips
Glass pane (8)
Pads for the
pane (8)
Glass