Options Menu - SEFRAM TR1500 Notice D'utilisation

•
Datalogger set-up
Open the set-up window (see paragrahh : Set-up screen)
Define the set-up desired then transfer it to the datalogger by clicking on « send set-up»
After sending, a message appears recalling the measurement starting and stopping conditions.
It is to be pointed out that to start a measurement, you must click on START . Sending the set-up is
not enough to start the acquisition.
•
Datalogger status
Reads the status of the datalogger , the response appears in the text area 9 figure 1. The following
status are possible :
Xxxx : number of measurements made
The datalogger status is only read periodically (to limit the consumption of dataloggers). It is
performed on every change of status (Scan datalogger, Start, Stop, Read measurements, Selection
of a datalogger in the list box 8 figure 1 ) and on request by clicking on « datalogger status»
•
Datalogger address*
Opening of the window « Give a new address »
To set the address of a datalogger. : value from 1 to 63
Do not give 2 dataloggers used simultaneously for the same address
Preferably use low addressess : 1,2,3,4 .so as not to spend too much time scanning for dataloggers.
•
Set a password / cancel a password
Give a 4 characters password . TR1500 asked a confirmation. Any keyboard character can be used.
Write the password in a safe area and take care that password is case sensitive.
If you loose your password the only possibility is to contact the manufacturer (by E mail if
possible).
If you don't need password don't use it!

12.4 Options Menu

•
Date time
Opens the « time setting » window
Transfers the time and date from the PC to the datalogger.
•
Serial port
Opens the serial port set-up window
Programs the serial port number used
Selects the speed : 19200bauds
•
English
Switches the software into English. The choice of language is saved.
•
Français
Switches the software into French. The choice of language is saved.
•
Maximum number of addresses
Choice of maximum number of addresses used when scanning dataloggers :
1 to 4
1 to 8
1 to 16
1 to 32
MTR15001F/03
Measurement stopped : xxxx
Measurement in progress :xxxx
In stand-by for starting date
Page 21 / 24
Sefram
Groupe General Electronique Mesure