7
List box to specify on which measurement the alarm is allocated
Internal temperature
External temperature
Voltage
Humidity
....
8
Alarm threshold entered via keyboard
9
Command button to call up the window to change the units
10 List box to select the measurement rate (1 s to 1 hour)
11 Starting condition of the measurement
Immediate – after pressing start
On a programmed date and time – after pressing start)
12 Stopping condition of recording
When the memory is full
On a programmed date and time
Looping :when the memory is full, the recording continues by writing over the oldest points
13 This command sends the set-up to the datalogger
14 Exits the datalogger set-up window
15 Recording time
Calculated from the number of channels selected, the size of the memory or difference between the
ending data and starting date.
12 Menus and sub-menus
12.1 Menu shortcut icons
The icon line or « toolbar » gives direct access to the menu functions.
Each icon corresponds to a command shortcut :
•
Scan
equivalent to the menu :
•
Conf
equivalent to the menu :
•
Start
equivalent to the menu :
If the measurement has already started, this icon is not active (start light grey)
•
Stop
equivalent to the menu :
If the measurement has already stopped, this icon is not active (stop light grey)
•
Read
equivalent to the menu :
•
Save
equivalent to the menu :
•
Open
equivalent to the menu :
•
Graph
equivalent to the menu :
•
Status
MTR15001F/03
« Datalogger » « Datalogger scan»
« Datalogger » « Datalogger set-up »
« Measurement » « Start measurement »
« Measurement » « Stop measurement »
« Measurement » «Read datalogger Measurements »
« File » « Save »
« File » « Open »
«Graph» « Settings »
Page 19 / 24
Sefram
Groupe General Electronique Mesure