Wireless Hand-held UHF
Microphone
These instructions are intended for users without
any specific technical knowledge Please read the
instructions carefully prior to operation and keep
them for later reference
The operating elements described can be
found on page 2
Contents
1
Overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
2
3
Applications . . . . . . . . . . . . . . . . . . . . . . . . . . 9
4
Power Supply . . . . . . . . . . . . . . . . . . . . . . . . . 9
5
6
via the menu . . . . . . . . . . . . . . . . . . . . . . . . . . 10
7
1 Overview
1 Display
Indication Meaning
Group number and channel number
or
radio frequency in MHz
Transmission power: high (50 mW)
When muted, the wireless microphone
will automatically switch off after the
time defined.
Wireless microphone muted
Battery symbol: indicates the battery sta-
tus in several levels; will start flashing
when the lowest level has been reached
Key lock activated
Note: Each time a button is pressed or the sliding
switch is used, the display backlight will be activated
for a few seconds
8
2 Status indicator
3 Sliding switch MUTE
4 Screw sleeve; when removed, the ultrasonic
5 Button
6 Sensor for ultrasonic transmission
7 Button
8 Buttons SET,
9 Battery compartment
10 Battery holder to secure the batteries in the
11 Contacts to charge inserted NiMH batteries
low (10 mW)
2 Important Notes
The unit corresponds to all relevant directives of
the EU and is therefore marked with
•
•
Green Batteries sufficiently charged
flashing in green: wireless microphone muted
Red
Batteries almost discharged
alternately flashing in red and green:
batteries almost discharged; wireless micro-
phone muted
Blue Receiver and wireless microphone successfully
synchronized via ultrasound
flashing in blue: reception error during ultra-
sonic transmission
When the wireless microphone is switched off:
to switch on the microphone (move the
sliding switch from the lower to the upper
position)
When the wireless microphone is in operation:
to mute (lower position) and unmute (upper
position) the microphone
sensor (6), the control buttons (7 and 8) and
the battery compartment (9) are accessible
to switch the microphone on (briefly
press the button) and off (keep the button
pressed for 2 seconds)
to activate and deactivate the key
lock (keep the button pressed for 2 seconds)
and
via its menu: see chapter 6 1
battery compartment; to open the holder, pull
hard so that it disengages
via the charging station 850CH-2
The unit is suitable for indoor use only Protect
it against dripping water, splash water and high
air humidity The admissible ambient tempera-
ture range is 0 - 40 °C
For cleaning only use a dry, soft cloth; never
use water or chemicals
(
)
to set the microphone