Turning On The Power - Boss RC-3 Mode D'emploi

NOTE
* To prevent malfunction and/or damage to speakers
or other devices, always turn down the volume, and
turn off the power on all devices before making any
connections.
* Before connecting or disconnecting any connection
cables, be sure all the volume controls in your system
are set to minimum.
* Use connection cables that do not contain a built-in
resistor. If you use cables that contain a resistor,
there might be insufficient volume from the device
connected to the AUX IN jacks, or it might be inaudible.
* Do not connect headphones to the OUTPUT jack.
Doing so may damage the headphones.

Turning On the Power

Inserting a connecting plug into the OUTPUT A jack turns on the
power to the unit.
Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on devices
in the wrong order, you risk causing malfunction and/or damage to
speakers and other devices.
Turn on the power to your guitar amp last.
When powering up
When powering down Turn off the power to your guitar amp first.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
Caution when turning off the power
While the RC-3 is in the following states, you must never
turn off the power (i.e., disconnect the plug from the
OUTPUT A jack).
Doing so may cause all the saved data to be lost.
• While the REC or PLAY indicator is lit
(during recording/playback/overdubbing)
• While the PLAY indicator is blinking rapidly
(while phrase memory is being read, or an internal
memory operation is occurring)
5