TERMA KTX 1 Mode D'emploi page 27

LOCAL MODE OPERATION (WITHOUT IR TRANSMITTER)
Heating mode
It is possible to set 5 temperature levels in the local mode. Settings are modified with
and buttons. Possible working levels are as follows: 0 (does not heat) and from 1 to 5,
each setting indicating a temperature range from 30 to 60 degrees Celsius accordingly.
icon indicates that the device is heating.
DRYER MODE (TIMER)
button is used to turn the mode on and set the time after which the device is to be
turned off automatically.
In order to activate the Dryer Mode:
– Press button shortly – display panel will show dryer working time of 1H (1 hour)
– Every subsequent pressing of the button will prolong dryer working time (2-4
hours)
In order to deactivate the Dryer Mode, set the time to 0H (press the
times) or turn the device off and back on.
While the Dryer Mode is on you can modify:
– temperature of the radiator – buttons
– Dryer working time left – button
Actual working time meter
The unique feature measuring the actual working time of the heating element adds up
the periods during which the device was using nominal electric power (during standard
operation the device regulates the temperature and uses very little power thanks to the
fact that it turns itself off for longer periods).
It can be checked at any time how much electricity has been used, ie. during all day's
operation. In practice it turns out to be up to a few dozens of percent less!
The number displayed on the meter reflects the actual energy consumption, therefore
you can measure the actual cost of energy used by multiplying the number on the meter
by the nominal heating output of the heating element and the price of electricity (1 kW).
button a few
and .
1. Meter reading:
Press and hold the button – the display panel will show letter E followed by 4 digits
separated by a hyphen (actual operating time of the device), ie. E..0..2..-..1..5 means
that the device was actually working for 2 hours and 15 minutes from the last time
the meter was zeroed.
2. Meter resetting:
Press and hold the button until E 00-00 comes up.
Setting permanent local mode
The device has been designed to work in a set, therefore, it will start searching for an IR
transmitter signal immediately after being turned on (
device does not find an active IR transmitter, the diode will keep flashing.
In order to turn it off, press and hold the
will mean that the controller is no longer searching for the IR transmitter and will keep
working in the local mode only.
In order to go back to work with IR transmitter, press and hold the
REMOTE MODE OPERATION (WITH IR TRANSMITTER)
Controller should start searching for an IR transmitter signal immediately
after it has been turned on – this is indicated by
display panel. Should this not happen, press and hold the
the icon starts flashing.
After being connected, the
When working in the remote mode, buttons
the Dryer Mode).
Button :
– press it short to turn the device off
– press and hold to switch to the Local Mode.
Dryer mode (timer).
Dryer in the Remote Mode is operated in exactly the same way as in the Local Mode,
meaning that it is operated via the KTX 4 controller:
button to activate the Dryer
– press
button a few times to modify Dryer operating time
– press
– press buttons to set the required temperature level during Dryer operation (see:
Local Mode operation – Dryer Mode).
The controller will automatically switch to the Remote Mode on expiry of the set time.
icon will start flashing). If the
button until the diode stops flashing which
button.
icon flashing on the
button until
zicon will stay on and a dash will appear.
and are not active (except when using