Télécharger Imprimer la page

TERMA KTX 1 Mode D'emploi page 22

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 45
KTX 1
Heating element unit heats the radiator that it is installed in. The device has
a user-friendly temperature regulation system allowing the device to work with only a
half or full of its heating output.
Button
is used to turn the device on / off.
When turned off and then back on again, the device will heat with the same heating
output as before it was turned off.
Button
is used to set the ECONOMICAL mode – this is indicated by a yellow diode
in the top left corner (the device will start operating by turning itself on and off every 7
seconds).
Button
is used to set the COMFORT mode (the device will operate with its full
output continuously) – this is indicated by a red diode in the bottom right corner.
Built-in temperature sensor protects the device from overheating, limiting the tempera-
ture of the radiator to maximum of 60°C.
Construction of the heating element unit as well as physical characteristics of the heating
agent cause that the bottom pipes (especially the two at the very bottom of the radiator)
may have a lower temperature than the remaining parts of the radiator – this is a normal
phenomenon.
PROBLEM SOLVING
Problem
Possible cause
Device is connected, no
Device is not turned on
diodes are on, heating ele-
ment does not heat.
Connection problem
Heating element does not
Device signals emergency,
heat, diodes are flashing
temperature sensor is
alternately.
damaged.
Heating element does
Thermal fuse is burnt
not heat, diodes indicate
or heating element is
correct operation.
damaged.
Heating element heats
Electronics damage.
although the device has
been turned off with the
button.
If the problem persists, please contact your local Distributor
Solution
Turn the device using
button
Check the connection,
plug and the socket.
Turn the device off, wait
for the radiator to cool
down and turn it back on.
Turn the device off, wait
for the radiator to cool
down and turn it back on.
Disconnect the device
completely from the
installation, wait for the
radiator to cool down and
turn it back on.

Publicité

loading

Ce manuel est également adapté pour:

Ktx 2Ktx 3Ktx 4