Télécharger Imprimer la page

FALMEC Gruppo Incasso Livret D'instructions page 26

Masquer les pouces Voir aussi pour Gruppo Incasso:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
lity of an explosion.
When discharging the battery, follow the respective regulations that are currently in force.
The manufacturer
Falmec S.p.A. - Via dell'Artigianato, 42 - 31029 Vittorio Veneto (TV) ITALY
declares that this radio control conforms to all of the technical regulations related to the
product and within the application confines of the directive 1999/5/CE.
All of the necessary radio frequency tests have been performed.
ETSI EN 300 220-2 V2.1.2 (2007-06)
ETSI EN 301 489-1 V1.4.1 (2002)
ETSI EN 301 489-3 V1.4.1 (2002)
INSTRUCTION FOR CHANGING THE FALMEC RADIO CON-
TROL
Disconnect the device from the mains.
To enter in the "change code mode" the button "Luce" and "Timer" (remote control) must
be pressed together for more than 3 seconds. After 3 seconds the LED starts flashing
slowly. Now, if you press the button "-" (remote control) within 5 seconds a new code
is generated in casual mode and memorized within the radio control. The memorizing is
confirmed by 3 quick LED flashings.
To get back to the default code: press "-" and "+" (remote control), together for more
than 5 seconds. After 5 seconds, the default code is memorized within the radio control.
The memorizing is confirmed by 3 quick LED flashings. Plug the device to the mains and
check that lights and motors are off. Press the timer button on the push-button panel for 2
seconds and, when the red LED lights up, press any of the radio control's buttons within 10
seconds. With this operation a new transmission code is registered.
H
FILTERS
1. METAL FILTERS
To remove the anti-grease metal fi lters, just act on the specifi c handle. In the perimeter
suction hoods remove the steel panel as indicated in fi g. H1 and then remove the metal
fi lters.
2. CHARCOAL FILTERS
To replace the charcoal filters, proceed as follows: remove the metal filters as indicated
above. The two filters hooked on the right and left sides of the conveyor can now be easily
accessed. See figure for assembly/replacement.
Note: gruppo incasso NRS.
To assemble or replace the charcoal filters, see the instructions in the specific optional
charcoal filter kit for each model.
Gruppo incasso filter code kacl. 920.
To order new charcoal fi lters contact the distributor/retailer.
ONLY FOR ITALY: Download the filter order module from the website:
www.falmec.com (access the drop-down assistance menu).
24
(to be used only in the case of malfunction due to interferences)
REMOVING AND REPLACING'S INSTRUCTIONS
EN 60950-1 (2001)
EN 50371 (2004-06)

Publicité

loading

Ce manuel est également adapté pour:

Gruppo incasso nrs