FALMEC Gruppo Incasso Livret D'instructions page 25

G
OPERATION
ELECTRONIC CONTROL PANEL
Light pushbutton
• ON: light on (the pushbutton is lit);
• OFF: light off;
Pushbutton -
Press to reduce motor speed
Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and
the timer LEDs).
Pushbutton +
Press to increase motor speed
Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and
the timer LEDs).
(In the 4-speed version the pushbutton + blinks. The fourth speed remains on for a set
duration of time. After 15 minutes the motor returns to the third speed).
Mode pushbutton
Function: it turns hood motor on and off.
The function "desired speed" enables to start the motor at the speed that was selected
before the hood was last turned off.
Timer and 'filter clogged' alarm pushbutton
• This function allows the automatic turning off of the hood after running for 15 minutes at
the speed previously set (the pushbutton shows a flickering light).
• After about 30 hours of running the pushbutton indicates the need for washing the metal
filters (the pushbutton shows a solid red light). To disable the alarm press the pushbutton
for a few seconds until the red light turns off. Then turn the hood off and on again to check
that the alarm has disappeared.
WARNING:
Install the hood away from sources of electromagnetic waves, as these could affect the
correct operation of the electronic system.
Maximum operating distance: 5 metres. The maximum operating distance could be less
than 5 metres in case of electromagnetic interference by other equipment.
Light pushbutton on remote control: light on/off.
– and + pushbutton: increase/decrease speed (to start the motor press either the + or the
– pushbutton).
Timer pushbutton: see instructions below.
RADIO CONTROL OPERATING AT 433.92MHZ.
Technical characteristics:
Power supply
Trans. consumption
Antenna
Oscillating type
Working temp.
By pressing one of the keys the led will illuminate and indicate the transmission of the
code. If the led does not illuminate, the battery may require replacing.
Replacing the battery: open the rear cover and insert the battery respecting the correct
polarity.
ATTENTION! If the battery is replaced with one that is of the wrong type there is the possibi-
3V lithium battery (type CR2032)
6mA
incorporated
SAW
-10°C to + 55°C