Publicité
(2) ADDRESS SETTING THROUGH REMOTE CONTROLLER (UP TO 8 INDOOR UNITS)
C
EG
At this point, press together FAN + IFEEL buttons for more than 7 seconds and release them pointing the remote controller
to the indoor unit receiver. Be sure to send the signal to only one indoor unit and that there is no other indoor unit that could
receive the same signal. If the signal is received, the indoor unit will emit 5 consecutive beeps.
NOTE: for electrical connections, refrigerant circuit connection and check, consult the Installation Instruction of outdoor
unit.
Set the remote controller as shown in the table.
BUTTON
working mode (COOL - HEAT)
set point
flap
filter
night mode / high mode
iFeel
Fan
26
Indoor unit A: 11°C
SETTING
Indoor unit B: 12°C
Indoor unit C: 13°C
AUTO
Indoor unit D: 14°C
Indoor unit E: 15°C
AUTO
Indoor unit F: 16°C
ON
Indoor unit G: 17°C
OFF
Indoor unit H: 18°C
Any
Any
Publicité
